Cryocan care, cleaning and signs of vacuum loss
UPADI · Published · 5 sources
Direct answer: a cryocan keeps nitrogen cold because of the vacuum between its inner and outer walls. Heavy frost or sweating on the outer body, or frost building fast around the neck, means that vacuum is failing. Move the semen to another can straight away; Semex warns such a tank "can go dry in a matter of hours" (Semex). Most vacuum failures start with a knock, a scratch on the neck or corrosion of the outer shell.
Signs of vacuum loss
| What you see | What it means | Source |
|---|---|---|
| A little frost near the top just after filling | Normal | MVE manual |
| Excessive frost or sweating on the outer jacket after the first few hours | Weak or no vacuum | MVE manual |
| Rapid frost build up around the outside of the neck tube | Vacuum loss and "imminent tank failure" | Semex |
| Frost or ice on the hardware in general | "Often an indication of continuous overflow or loss of vacuum"; do not use while ice is present | Georgia Tech |
| Weekly level drop much larger than usual | Rising evaporation; check the vacuum | DAHD SoP asks for a weekly record on 35 L cans for this reason |
Watch a new can for a few hours after its first fill, as the MVE manual advises. Keep a spare can filled for emergencies (same manual).
What damages a cryocan
- Drops and knocks. "If a vessel experiences a drop, hit, or blow, it can suffer immediate or premature vacuum failure" (MVE manual). Semex adds that rough handling can damage the seal between neck tube and inner liner (Semex). Lift with both handles.
- Scratches in the neck. "Scratches can cause premature vacuum failure" (MVE manual). Lower and raise canisters straight, without scraping.
- The vacuum port. Never touch or remove it, and never spill nitrogen on it; tampering destroys the vacuum and voids the warranty (MVE manual).
- Standing on concrete. Moisture, minerals and abrasion from concrete can corrode the aluminium shell; "if perforation occurs, vacuum loss and tank failure is certain". Stand the can on a wooden pallet or rigid foam (Semex).
- Chemicals, soil and wet floors. Keep the bottom clean and away from chemicals, fertilisers, soil and moisture (MVE manual). Semex advises against keeping a tank in the milk room because cleaning chemicals and humidity attack the shell.
- Weather. MVE says indoor use only and never leave a vessel outdoors (MVE manual).
- Lying down. Keep the can upright; never tilt it or lay it on its side (MVE manual).
Daily and weekly care
| When | Task | Source |
|---|---|---|
| Always | Keep the can where you can see into the neck, in a ventilated, dry, dust free place | DAHD SoP |
| Every use | Lift the cork straight up, do not twist; replace it after use | MVE manual; Semex |
| Weekly (35 L cans) | Measure and record the LN2 level | DAHD SoP |
| Weekly | Look at the outer body and neck for frost or sweating | MVE manual, Semex |
| When not in use | Keep the can locked | Semex |
| Refilling | Never fill above the bottom of the neck tube | MVE manual |
Never seal or tape the cork: gas must escape. See liquid nitrogen safety.
Cleaning
| Part | How | Source |
|---|---|---|
| Outside | Lightly dampened cloth with mild soap solution | MVE manual |
| Outside, near the neck | No strong jet of water: water in the neck can freeze the cork in place and the pressure "can rupture the tank" | Semex |
| Inside (empty, for decontamination) | 10% chlorine bleach and 90% water, then rinse and dry fully, preferably upside down | MVE manual |
| Never | Petroleum based cleaners | MVE manual |
Move the semen to another can before any inside cleaning, and let the empty can warm up fully first.
Yearly check
The MVE manual describes an annual evaporation check: fill the can about half full, weigh it, weigh it again after 24 hours and compare with the specified rate (MVE manual). It notes that age, inventory, environment, shipping and accessories can all raise the rate. A simpler way for a technician is to compare this year's weekly level records with last year's.
Life and warranty
- Semex expects a modern storage tank to last "a minimum of 10 to 12 years" (Semex). MVE's manual states a five year life expectancy for its dewars, with vacuum warranties of 3 to 5 years by series (MVE manual). Life depends on the make and on handling.
- NDDB Dairy Services asked suppliers for test certificates for vacuum retention and static evaporation rate, and at least two years' warranty against manufacturing defects (NDDB DS tender, 2025). Ask for the same when you buy.
- Warranties usually exclude misuse, abuse and accidents (MVE manual). Inspect a new can on delivery; MVE asks for inspection within three days.
For warranty terms on a specific model, ask UPADI before purchase. Related: how long semen lasts in a cryocan, cryocan size guide.
Questions and answers
Is frost on the neck of a cryocan a fault?
A little frost near the top just after filling is normal, the MVE manual says. Excessive frost or sweating on the outer body after the first few hours, or frost building fast around the neck, points to weak or lost vacuum.
What should I do if my cryocan loses vacuum?
Move the semen to another filled container at once. Semex warns that a tank in this state can go dry in a matter of hours. Then contact the supplier about repair or warranty.
How do I clean a cryocan?
Wipe the outside with a cloth dampened in mild soap solution, never with petroleum based cleaners. Do not spray water near the neck. The MVE manual suggests 10 percent bleach for decontaminating the inside of an empty vessel, then rinsing and drying it fully.
Sources
- Operating Manual for MVE Liquid Nitrogen Dewars (11624417 Rev T), Chart Inc. (MVE) (accessed 2026-11-19)
- Semen Tank Management: A Dozen Do's and a Few Don'ts, Semex (article by Bruce Poulin, Progressive Dairyman) (accessed 2026-11-19)
- Laboratory Safety Fact Sheet: Liquid Nitrogen (rev. 07/31/2025), Georgia Institute of Technology, Environmental Health and Safety (accessed 2026-11-19)
- Standard operating procedures for Artificial Insemination Technicians / MAITRIs (OM dated 24 January 2026), Department of Animal Husbandry and Dairying, Government of India (hosted by Odisha DAHVS) (accessed 2026-11-19)
- Bidding Document for LN Container Supply for RGM and Semen Station of NDDB Dairy Services (June 2025), NDDB Dairy Services (hosted by Alamadhi Semen Station) (accessed 2026-11-19)



