Skip to content

Artificial insemination in cattle step by step

UPADI · Published · 3 sources

Direct answer: confirm the animal is in heat, thaw the straw at 37 °C for 40 to 45 seconds, load it into a warm gun with a sheath, guide the gun through the cervix by rectal hold, and deposit the semen slowly just past the cervix. Then record the AI on Bharat Pashudhan with the farmer's OTP. Every step below follows the Government of India's SoP for AI technicians and MAITRIs (DAHD, OM of 24 January 2026), which made the data entry steps mandatory from 1 April 2026.

AI must be done by a qualified AI technician, at the farmer's door, a veterinary hospital or a dispensary (same SoP). This page is a checklist for trained technicians, not a training course.

1. Before you leave the centre

Check that the kit has everything the SoP lists (DAHD SoP):

Item Item
Straw cutter or sharp scissors Thermometer (good quality)
Thawing flask Forceps
Single packed sheaths AI gun with container (universal gun)
Plastic gloves Clean towel
Thermos flask with hot water Apron
1.5, 2 or 3 litre cryocan with the semen straws needed Gum boots

Canisters should be properly tagged with the semen description, and the cryocan kept with enough liquid nitrogen (same SoP).

2. At the farm: check the animal

  1. Identify the cow or buffalo and check its past breeding record (DAHD SoP). The animal must be ear tagged, with the owner's Aadhaar and mobile number verified.
  2. Confirm heat. The SoP names the best sign as "clear, transparent, viscous and ropy vaginal discharge". For timing, see heat detection and AI timing.
  3. Do a rectal examination of the genital tract before preparing the gun (same SoP).

3. Thaw and load

  1. Lay out gloves, sheath, gun, scissors, forceps, tissue and towel first.
  2. Set the thawing water to 37 °C with the thermometer.
  3. Take the straw out with cooled forceps within 10 seconds, never lifting the canister above the frost line.
  4. Shake off the nitrogen and thaw horizontally at 37 °C for 40 to 45 seconds.
  5. Keep the gun and sheath near 37 °C, not very hot or cold.
  6. Wipe the straw dry. Check the air bubble is at the laboratory seal end.
  7. Load the straw, cut it at a right angle just below the laboratory seal, fit the sheath and lock it firmly with the O ring.

All from the DAHD SoP. In cold weather, keep the loaded gun warm against your body until you insert it, to avoid cold shock (University of Arizona). Full detail: semen straw thawing.

4. Inseminate

The SoP's steps (DAHD SoP):

  1. Wear a shoulder length glove, preferably on the left hand, and hold the gun in the right.
  2. Lubricate the glove with liquid paraffin or another suitable lubricant.
  3. Clear dung from the rectum without ballooning it.
  4. Clean the vulva with water and wipe with tissue paper.
  5. Never let the gun tip touch the animal's coat, anus or vulva.
  6. Insert the gun at about a 30 degree angle up to the vaginal fornix, so it does not enter the urethral opening or bladder.
  7. Hold the cervix firmly through the rectum and stretch it slightly forward to smooth out the vaginal folds.
  8. Make sure the tip is not caught between cervical rings or in a fold.
  9. If the animal moves, stop. Wait until it is still.
  10. Push the piston slowly, over about 5 seconds, to deposit semen just outside the internal os, so it drains into the body of the uterus.

Blood on the gun tip or glove means too much force was used. Be gentle and patient (same SoP).

5. After insemination

  • Recheck the semen ID: bull and batch number.
  • Dispose of the sheath, glove and tissue properly; clean the gun if needed.
  • Give the farmer the AI fee receipt.
  • Advise the farmer to download the 1962 app.

All from the DAHD SoP.

6. Record on Bharat Pashudhan

Step SoP rule
Upload Enter the AI in the Animal Breeding module of the Bharat Pashudhan portal
Confirm Enter the OTP sent to the farmer's registered mobile
Farmer absent Capture a date and location stamped photo through the NDLM app
No network (dark zone) Capture the photo in the app; it syncs when network returns
Counting Only one AI per heat cycle counts for incentives and conception rate
Incentive Released only after the pregnancy diagnosis is uploaded

Source: DAHD SoP.

7. Follow up

When What Source
Next 12 to 24 hours Farmer keeps the animal under watch and away from scrub bulls DAHD SoP
If heat signs persist after 18 to 24 hours Repeat AI DAHD SoP
18 to 21 days, and 36 to 42 days Watch for return to heat; technician follows up around day 21 DAHD SoP
45 to 90 days (data entry section) or after 3 months (farmer advice section) Pregnancy diagnosis, uploaded on Bharat Pashudhan DAHD SoP
Quarterly until calving Follow up every pregnant animal DAHD SoP
At calving Register the calf with a physical or virtual tag; a virtual tag becomes physical within 180 days DAHD SoP

The SoP gives two windows for pregnancy diagnosis in different sections. The TANUVAS guidance on Vikaspedia says 45 to 60 days after breeding, by a qualified veterinarian (Vikaspedia). Follow your State Implementing Agency and your veterinarian.

8. Keep the kit ready for the next call

Clean the gun piston and scissors with water after each AI. Wash the gun, scissors and accessories with hot water at least once a week, air dry them, and sanitise with isopropyl alcohol. Never use surgical spirit or soap: the SoP calls them lethal to semen (DAHD SoP).

UPADI supplies the AI gun, AI sheaths and field cryocans such as the BA-1.5 and BA-2X.

Related: common AI failures, AI gun and sheath guide.

Animal health problems, repeat breeders and any treatment are for your veterinarian.

Questions and answers

Where is semen deposited during AI in a cow?

The DAHD SoP says to push the piston slowly, over about 5 seconds, to deposit semen just outside the internal os of the cervix so that it drains into the body of the uterus.

When should AI be repeated?

The SoP says to call for repeat AI if heat signs persist 18 to 24 hours after AI. Otherwise watch for heat again at 18 to 21 days and at 36 to 42 days.

When is pregnancy diagnosis done after AI?

The SoP asks the technician to do pregnancy diagnosis within 45 to 90 days of AI in its data entry section, and advises the farmer to call for diagnosis after 3 months in its advice section. Follow your state's instruction and your veterinarian.

Is OTP needed to record AI on Bharat Pashudhan?

Yes. Under the SoP, from 1 April 2026 the AI is confirmed by an OTP sent to the farmer's registered mobile. If the farmer is not present, a photo is captured on the NDLM app.

Sources

  1. Standard operating procedures for Artificial Insemination Technicians / MAITRIs (OM dated 24 January 2026), Department of Animal Husbandry and Dairying, Government of India (hosted by Odisha DAHVS) (accessed 2026-11-19)
  2. Semen Handling 101 (az2153), The University of Arizona Cooperative Extension (accessed 2026-11-19)
  3. Breeding Management (from Expert System for Cattle and Buffalo, TANUVAS), Vikaspedia, Government of India (accessed 2026-11-19)

Products in this article

All UPADI Knowledge articles